Technical Documents

Suitable Surfaces

Application Methods

Temperature Usage

Coverage Guidelines

Exact coverage varies depending on the type of stain and the porosity of the surface material.

Technical Data

Instructions for Use

Bare Brick Stone & Masonry Graffiti Remover (BBSM) is applied to the surface with a nylon brush, broom or pump-up sprayer, 3 times at 3 minute intervals, liberally flooding the graffiti / stain with the product. For typical graffiti, approximately three minutes after the final application, rinse using a hot or cold pressure washer (hot is best) at low pressure. If one is not available then a stiff nylon brush and bucket of water may suffice. 

Agitation, as you apply this product, can be of great assistance. Continued experience with the product will enable the user to judge how many applications are necessary for varying surfaces and particular spray cans. 

On older / thicker graffiti, patience is the key. Keep the graffiti wet with the product, as long as possible before rinsing. 

Remember, a pressure washer in this instance is used as a quick-release rinse of the dissolved graffiti, and not the primary means of cleaning. Ideally, use 1500 - 2000 psi with a 15º or 25º fan jet at about 6 inches from the surface.

When rinsing dissolved graffiti with a pressure washer try to remove a LITTLE of the graffiti from the bottom of the tag without wetting the whole area. If satisfied, then proceed to full scale. Wash the whole area from top to bottom. Remember if the remover has not done its job then no amount of ‘blasting’ will fix the problem. Failures are usually a result of not flood coating adequately and not leaving the product on long enough and cannot be resolved by blasting too close or at higher pressures. Do not use ‘turbo’ type nozzles, or blast too close, as you may cause damage and will possibly only remove a small percentage more.

Tips for Effective Use of Bare Brick Stone & Masonry Graffiti Remover

TIP 1 Some spray cans such as reds can stain surfaces. Other spray cans change colors once Bare Brick Stone & Masonry Remover has been applied. For complete and total removal of these stains use our FELTPEN FADEOUT after or while BBSM is still on the stain.

TIP 2  If you are fixing someone else’s former failure and may be having problems, then BBSM can be left overnight on the wall (if safe to do) ensuring maximum dwell time. Return in the morning and the problem will usually be solved with another application and a wash-off.

TIP 3  As a general rule, avoid trying to remove spray can graffiti from porous unpainted surfaces, whilst the walls are facing the hot summer sun. Wherever possible, try to work in the shade or during a cooler time of day. On days when there is a likelihood of the graffiti remover drying out within minutes or less, the wall can be thoroughly wet with water first and towel patted dry BEFORE applying BBSM).

Instructions for use: 

Removing Graffiti from Painted Surfaces

1. Thoroughly wet down the wall with pressure washer.
2. Using a soft nylon broom and a rectangular bucket containing BBSM, apply and agitate about 10 square feet of the graffiti until approximately half disappears (the graffiti is dissolving and running).
3. Using low pressure, quickly rinse the treated area, and thoroughly wet down ahead to repeat the same on the next section. Approximately 95% of the spray can graffiti should be gone. If you find that it is affecting the underlying paint, you will have to shorten your initial application time. The reason you stop at approximately half dissolved is because the rinsing tends to remove another 50% more than you have.
4. Carefully spot-clean any uncleaned areas using SENSITIVE SURFACE GRAFFITI REMOVER.

Removing Graffiti from Wooden Fences

If color matching and painting is not a preferable option, BBSM may be used to clean a wooden fence. Always test first in an inconspicuous area to ensure there is no discoloration. Use BBSM per instructions for brick, stone and masonry surfaces above. You will most likely leave a clean patch when rinsing with a pressure washer requiring you to rinse an entire section of the fence. 

If BBSM appears to darken the surface on your test patch, TRANSGEL may be a better option.

Removing Graffiti from Trees

Brush on BBSM and agitate with the brush as you apply. Depending on the type of graffiti, you may need more than one coat and a little dwell time between coats to ensure the spray can is fully dissolved before rinsing. 

Once the graffiti has dissolved, use a pressure washer to rinse, taking care not to blast too close to the tree so as not to remove any bark or etch the surface. Using a yellow 15° tip, or green 20° tip, stand back as much as possible and keep the wand moving along the tree to avoid damage, as seen in the photos below; Alternatively, a stiff bristled nylon scrub brush and a bucket of water can be used to rinse the tree’s surface.

Removing Oil Stains from Pavements and Driveways

Flood coat BBSM onto oil stains on concrete and leave for as long as possible. Agitate with a nylon scrubbing brush whilst adding more applications. When satisfied that all oil is dissolved, use high-pressure water to rinse away the stain (hot water is best).

Removing Chewing Gum Residue (Gum Ghosting)

Some stains are often left after removing gum with hot, high-pressure water or steam. Brush BBSM onto the residue and high-pressure hot wash. 

Removing Smoke Damage from Brick or Stonework

BBSM can be highly effective in the removal of burnt-in or resistant smoke damage. Use as instructed for brick, stone & masonry applications.

Safety Issues

BBSM is very safe to use in comparison to most graffiti removal products. However, the intended use is for stripping paint, waxes and oils from building surfaces and is thus naturally much more aggressive on skin and eyes than normal everyday cleaners. If the intended user is not familiar with or confident in implementing the safety precautions below, we urge that they do not use the products.

1. Always wear solvent alkali protective gloves, goggles and long sleeve clothing. 
2. Be sun smart. Wear a wide-brimmed hat; after all, you are outside. 
3. Always know where water is available in case of a splash. 
4. Carry a spare set of clothing. Do not leave contaminated clothing on. 
5. Use in well-ventilated areas.

Limitations

• Always wear solvent alkali protective gloves, goggles and long sleeve clothing. 
• Be sun smart. Wear a wide-brimmed hat; after all, you are outside. 
• Always know where water is available in case of a splash. 
• Carry a spare set of clothing. Do not leave contaminated clothing on. 
• Use in well-ventilated areas.

Caution

Before commencing any large-scale use, always test first in an inconspicuous area. This product is designed to remove all types of markers and stains, and may have an unpredictable or even damaging result on certain man-made or stained surfaces. If necessary, wait for the surface to dry to ensure perfect results.

Environmental Care

World's Best Bare Brick, Stone and Masonry Graffiti Remover is biodegradable and conforms to all statutory environmental requirements for graffiti removal including VOC limits. Designed to be fast, effective and non-damaging requiring very little rinsing water. If necessary, water can be collected using a wet vac and disposed of safely.

We believe nothing other than rainwater should enter our precious stormwater systems.

Your shipment is our number one priority!

• All Orders received before 12pm CDT are processed same day. 
• All Orders under 200 pounds ship ground via Loomis Express. Orders above 200 pounds may be shipped via LTL carrier.
• Consolidated Shipping Charges for Orders are calculated as follows:

• ‘Free Shipping’ Items excluded from all Shipping Charges.
• If some of your items qualify for Free Shipping but others do not, Shipping Charges will be calculated on the total order value less the Items which qualify for Free Shipping. 
• Shipping of Dangerous Goods will incur an additional C$20 charge per Dangerous Goods (DG) item. Our policy is to limit the quantity of Dangerous Goods to a maximum of 6 (C$120) per order.

We reserve the right to use a variety of carriers to deliver product and will contact you to confirm the best shipping method available when your order is processed.

• Exact Freight Method and estimated delivery date will be confirmed via email.
• International Orders: Purchase through your local distributor or contact sales@graffitiremovalinc.ca. 
• This shipping policy is for internet orders processed through this website and applies to Canada Ground customers located in the 10 Provinces. We cannot ship to Territories and are unable to provide airway bills to freight forwarders.